2023/11/30, Volume 11, Issue 2, pp.161-165

Development and Substantiation of Energy-Saving Methods for Controlling the Modes of Operation of Centrifugal Pumping Units in Complicated Operating Conditions


Javokhir Toshov, Azamat Makhmudov, Oybek Kurbonov, Golib Arzikulov and Gulnoza Makhmudova


Abstract: Rational and energy efficient operation of pumps for pumping and transporting liquids used in difficult conditions of mining is possible due to the implementation and use of modern methods of managing the operating modes of the pumps. Nowadays, the methods and resources used to regulate the operating modes of pumping units do not meet modern requirements, and many mines still use outdated methods of regulating the operating modes of pumps, which entails significant energy losses and an increase in the cost of the transported liquid. In the article, the methods of reducing electricity losses and the impact on the performance of pumping units were considered. It is concluded that this method of regulating work makes it possible to operate pumping units in the working area. Our article considers and experimentally substantiates the possibility of achieving savings in electrical energy, as well as increasing the reliability of the operation of pumping units based on the use of modern methods of regulating operating modes.

Keywords: Pump, Efficiency, Energy Efficiency, Operating Mode, Pressure, Flow, Throttle, Valve, Characteristic, Pressure, Fluid Flow.

DOI: 10.25673/113008

Download: PDF

References:

  1. V.I. Bessarab, R.V. Fedyun, and V.A. Popov, “Control of the mining drainage plant in emergency and abnormal modes of the work,” Scientific works of DonNTU, Donetsk, vol.106, pp. 26-33, 2006.
  2. V.G. Mikhailov and P.V. Petrov, “Calculation and experimental method for diagnosing the degradation of some units of submersible centrifugal pumps,” Bulletin of USATU, Ufa, vol. 1, pp. 82-93, 2009.
  3. Yu.P. Stashinov, D.A. Bochenkov, V.V. Volkov, “Energy-saving regulation of the operation mode of the main drainage installations of mines and pits,” Notes of the Mining Institute, Moscow, vol. 192, pp. 209-211, 2011.
  4. J.B. Toshov, B.R. Toshov, B.N. Baratov, and A.L. Haqberdiyev, “Designing new generation drill bits with optimal axial eccentricity,” Mining Informational and Analytical Bulletin, Moscow, vol. 9, pp. 133-142 2022, doi: 10.25018/0236_1493_2022_9_0_133.
  5. R. Ergashev, O. Azizov, N. Dehkanova, and A. Bozorov, “Development of energy-saving modes of irrigation pump stations,” IOP Conf. Series: Materials Science and Engineering, vol. 883, pp.1-6, 2020, doi:10.1088/1757-899X/883/1/012017.
  6. I. Bakman, “High-Efficiency Predictive Control of Centrifugal Multi-Pump Stations with Variable-Speed Drives” PhD thesis, Tallinn University of Technology, Tallin, p. 149, 2016.
  7. Y. Wang, K. Luo, K. Wang, H. Liu, Y. Li, and X. He, “Research on pressure fluctuation characteristics of a centrifugal pump with guide vane” Journal of vibroengineering, Lithuania, vol. 19 (7), pp. 5482-5497, 2017.
  8. L. Gevorkov, “Simulation and Experimental Study on Energy Management of Circulating Centrifugal Pumping Plants with Variable Speed Drives” PhD thesis. Tallinn University of Technology, Tallin, p.115, 2017.
  9. I. Nikolenko and P. Shvagirev, “Analysis of methods of improving energy efficiency of pumping stations power units of water supply systems,” Econtechmod. an International Quarterly Journal, no. 1, vol. 7, pp. 67-77, 2018.
  10. A. Makhmudov, O.M. Kurbonov, and M.D. Safarova, “Research of the pressure characteristics of the centrifugal water drainage plant of the WCP 25-60G brand,” Australian Journal of Science and Technology, Melbourne, vol. 4(2), pp.279-282, June 2020.
  11. M. Bogdevicius, J. Januteniene, R. Didziokas, S. Razmas, V. Skrickij, and P. Bogdevicius, “Investigation of the hydrodynamic processes of a centrifugal pump in a geothermal system,” Transport, Lithuania, vol. 33 (1), pp. 223-230, 2018.


    HOME

       - Call for Papers
       - For authors
       - Important Dates
       - Conference Committee
       - Editorial Board
       - Reviewers
       - Last Proceedings


    PROCEEDINGS

       - Volume 12, Issue 1 (ICAIIT 2024)        - Volume 11, Issue 2 (ICAIIT 2023)
       - Volume 11, Issue 1 (ICAIIT 2023)
       - Volume 10, Issue 1 (ICAIIT 2022)
       - Volume 9, Issue 1 (ICAIIT 2021)
       - Volume 8, Issue 1 (ICAIIT 2020)
       - Volume 7, Issue 1 (ICAIIT 2019)
       - Volume 7, Issue 2 (ICAIIT 2019)
       - Volume 6, Issue 1 (ICAIIT 2018)
       - Volume 5, Issue 1 (ICAIIT 2017)
       - Volume 4, Issue 1 (ICAIIT 2016)
       - Volume 3, Issue 1 (ICAIIT 2015)
       - Volume 2, Issue 1 (ICAIIT 2014)
       - Volume 1, Issue 1 (ICAIIT 2013)


    PAST CONFERENCES

       ICAIIT 2024
         - Photos
         - Reports

       ICAIIT 2023
         - Photos
         - Reports

       ICAIIT 2021
         - Photos
         - Reports

       ICAIIT 2020
         - Photos
         - Reports

       ICAIIT 2019
         - Photos
         - Reports

       ICAIIT 2018
         - Photos
         - Reports

    ETHICS IN PUBLICATIONS

    ACCOMODATION

    CONTACT US

 

DOI: http://dx.doi.org/10.25673/115729


        

         Proceedings of the International Conference on Applied Innovations in IT by Anhalt University of Applied Sciences is licensed under CC BY-SA 4.0


                                                   This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License


           ISSN 2199-8876
           Publisher: Anhalt University of Applied Sciences

        site traffic counter

Creative Commons License
Except where otherwise noted, all works and proceedings on this site is licensed under Creative Commons Attribution-ShareAlike 4.0 International License.